"root strip" was semantically incorrect and did cause some confusion
as it never stripped the root but the client's request path.
Discussed with many. Heads up: this is a grammar change that also
affects acme-client(1) configurations (see current.html).
OK claudio@
Adjust filters and comment them to explain the basic operation.
Use large-community and a prefix-set to ensure no bad prefixes are
leaked to eBGP speakers.
With and OK job@
immediately above also uses this notation, it's shorter, and it keeps
two examples in the man page which claim to be the same as the default config
(but with exceptions) in sync;
ok gilles
4.2 BSD takes a signal mask as argument while POSIX sigpause(int
sig) expects a single signal. Do not expose our traditional BSD
sigpause(3) to XPG/POSIX sources.
OK guenther@
needs (looking at you sgi, but others required this before). This is for
the circumstances we need pagesize known at compile time, not getpagesize()
runtime. Use it for malloc storage sizes, for shm, and to set pthread stack
default sizes. The stack sizes were a mess, and pushing them towards
page-aligned is healthy move (which will also be needed by the coming
stack register checker)
ok guenther kettenis, discussion with stefan
are signalled to shutdown cleanly. Wait for each to finish to avoid too much
busy work at once; this may need revising if it turns out to be too slow with
a larger number of VMs (e.g. signal/delay/signal/delay/... then wait for
shutdowns), but let's avoid making it more complex unless we know it's needed.
Based on a diff from abieber@, discussed with mlarkin@ aja@ rpe@, ok rpe
to skip backup or temp files.
- test if the patterns matched actual files
- warn if ifcreate() fails on an interface and continue with the
subsequent interfaces in the list instead of return'ing
OK dlg sthen tb
These PATH helpers failed to quote their input properly leading to shell
code execution. Noone noticed since import (over 21 years ago), so wipe it.
OK tb rpe
- In ifcreate() use the exit code of the {} block directly
- In vifscreate(), use the ifconfig -C output directly in the for _vif loop
- Remove superfluous and somewhat confusing comment
OK dlg kn sthen
dlg